Overview



The PT-571 is a DGKat™ twisted pair transmitter for HDMI signals. The PT-571 converts an HDMI signal to a single twisted pair signal and the PT-572 converts the twisted pair signal back to an HDMI signal.

- Max. Data Rate - 1.65Gbps.
- HDTV Compatible.
- HDCP Compliant.
- DGKat Signal Integration - Kramer’s unique technology for converting TMDS as well as control and communication to signals that run over twisted pair cables. We strongly recommend using Kramer DGKat cables designed specifically for optimum performance.
- HDMI Support - HDMI (V.1.4 with Deep Color, x.v.Color™, Lip Sync, HDMI Uncompressed Audio Channels, Dolby TrueHD, DTS-HD).
- 3D Pass-Through.
- System Range - Up to 90m (295ft) at 1080i, or up to 30m (98ft) at 1080p on shielded BC-DGKat524 cable. Up to 90m (295ft) at 1080i, or up to 70m (230ft) at 1080p on shielded BC-DGKat623 cable. Up to 100m (330ft) at 1080i or up to 90m (295ft) at 1080p on shielded BC-DGKat7a23 cable.
- Cable - Requires shielded twisted pair (STP) cable. For optimum range and performance use, use Kramer's BC-DGKat524, BC-DGKat623 and BC-DGKat7a23 cables. Note that the transmission range depends on the signal resolution, graphics card and display used. The distance using non-Kramer CAT 5, CAT 6, and CAT 7 cables may not reach these ranges. Use only shielded cable where both ends of the shield are soldered to ground.
- EDID PassThru - Passes EDID signals between the source and display.
- Status LED - Lights red when receiving power only, orange when output and power are attached, and yellow when both an active input and output are attached.
- Power Connect System - A single connection to the transmitter powers the receiver.
- Ultra-Compact Pico TOOLS - 4 units can be rack mounted side-by-side in a 1U rack space with the optional RK-4PT rack adapter.




Specification


Technical Description: Kramer Electronics HDMI over Twisted Pair Transmitter AV transmitter Black

Features
Product colour:
Black
Bandwidth:Bandwidth is the difference between the upper and lower frequencies in a continuous set of frequencies. It is typically measured in Hertz (Hz). A key characteristic of bandwidth is that any band of a given width can carry the same amount of information, regardless of where that band is located in the frequency spectrum. For example, a 3 kHz band can carry a telephone conversation whether that band is at baseband (as in a POTS telephone line) or modulated to some higher frequency.
1.65 Gbit/s
LED indicators:
Yes
Supported graphics resolutions:The graphic resolutions that can be displayed by the device. The graphic resolution describes the width and height dimensions of a display, such as a computer monitor, measured in pixels.
1920 x 1080 (HD 1080)
Supported video modes:The video modes that can be displayed by the device.
1080p
Maximum transfer distance:The greatest distance over which the data/signal can be transferred.
100 m
Cable types supported:
Cat5, Cat6, Cat7
Maximum resolution:The maximum number of pixels that can be displayed in the image. It is usually quoted as width × height,: for example, "1024 × 768" means the width is 1024 pixels and the height is 768 pixels.
1920 x 1080 pixels
Type:Characteristics of the device.
AV transmitter

Ports & interfaces
BNC input ports:Ports (sockets) to connect BNC inputs. The BNC connector (Bayonet Neill–Concelman) is a miniature quick connect/disconnect RF connector used for coaxial cable.
0
BNC output ports:
0
Component video (YPbPr/YCbCr) in:The number of sockets (ports) for RF (radio frequency) connections into the product.
0
Component video (YPbPr/YCbCr) out:The number of sockets (ports) for RF (radio frequency) connections out of the product.
0
Composite video in:The socket (port) for the composite video input (white cable).
0
Composite video out:The socket in the device for the composite video, which is an analog video transmission (no audio) that carries standard definition video typically at 480i or 576i resolution. The cables for composite video are normally yellow.
0
SCART ports quantity:The number of sockets (ports) for SCART connections.
0
S-Video inputs quantity:The number of ports (input sockets) for S-Video, which is a signalling standard for standard definition video, typically 480i or 576i.
0
S-Video outputs quantity:The number of ports (output sockets) for S-Video, which is a signalling standard for standard definition video, typically 480i or 576i.
0
VGA (D-Sub) ports quantity:Number of VGA (D-Sub) ports (connecting interfaces) in the device. The VGA (D-Sub) connector is a 15 pin connector between a computer and a monitor. It was first introduced in 1987 by IBM.
0
DVI input ports:
0
DVI output ports:
0
HDMI in:Port (socket) for HDMI input.
1
Number of HDMI outputs:
0
VGA (D-Sub) input ports:Sockets in the device for VGA (D-Sub) inputs, which are sockets with 15 holes. The 15-pin VGA connector is found on many video cards, computer monitors, and high definition television sets.
0
VGA (D-Sub) output ports:
0
RJ-45 output ports:
1
RJ-45 input ports:
0

Power
Current:
0.25 A
External power adapter:
Yes
Operating voltage:Defines the range of operating voltages available
12 V

Weight & dimensions
Weight:Weight of the product without packaging (net weight). If possible, the net weight is given including standard accessories and supplies. Please note that sometimes the manufacturer leaves out the weight of accessories and/or supplies.
140 g
Dimensions (WxDxH):Dimensions of the product (Width x Depth x Height).
62 x 52 x 24 mm


Product details


PT-571 Kramer 7290012307560

Kramer Electronics HDMI over Twisted Pair Transmitter AV transmitter Black

£176.40 and In stock

SKUPT-571

Kramer Electronics HDMI over Twisted Pair Transmitter AV transmitter Black

Quick Code: Q645378 MPN: PT-571

You need to be logged in to see Prices

Log In For Prices
Dont have an account? Contact Us